• Steam - Standard design pressure of 150 PSI; Low pressure also available.
• Hot Water - Standard design pressure of 30 PSI; Optional to 160 PSI, 250° F
• Steam pressure gauge with syphon and test cock
• Combination low water cutoff and pump control with water column blowdown valve
• Probe auxiliary low water cutoff and relay
• ASME safety relief valve
• Operating and high limit pressure controls
• Steam outlet valve, slow opening blowdown valve, feedwater shut off valve, and check valves included on boilers through 30Hp.
• Burner/Boiler UL Packaged
• Convenient eye-level burner
• Factory assembled; fully automatic
• Simple and inexpensive to install

You can package the Cyclone along with a feedwater system.  Have everything mounted on a single skid for easy installation!

More Storage:

• Capacity to handle swing and spike loads - quick recovery - quick response.
• The larger steam-release surface is calmer, reducing carry over of unevaporated water.
• The resulting drier steam also reduces system scaling.
• In addition, dry steam helps to eliminate unnecessary extra condensate. Energy and fuel are saved. Longer life results.

Inspection Access:

• The waterside openings are located in the most effective positions. The lower handholes offer far better access for both cleanout and inspection.
• These more functional locations avoid the obstructing handhole “tunnels” used by our competitors.
• The top opening offers a strategic view of the furnace crown sheet.

4-Pass Design:

• The gases leaving the furnace are split four ways and travel through four individual serpentine fin passages to the stack outlet.
• Each quarter of the heat
  travels its own four-pass path (see illustration below).
• Heat transfers evenly to the fins and boiler shell, eliminating the metal stress due to uneven heat transfer common in other designs.